SEAM Seminar, CRSI: Time Saving Design Aids and Pile Caps

SEAM will be hosting a seminar to be put on by Mike Mota, Vice President of Engineering at the Concrete Reinforcing Steel Institute. The presentation will include two separate portions:

Design of Pile Caps (2 hours)
This presentation provides an overview of the new CRSI Pile Cap Design Guide The guide has been developed as a stand-alone publication intended to provide the practicing engineer with a detailed overview of pile cap design, detailing, and analysis methodologies that represent the current state of practice in the industry and meet the latest codes and standards including the 2012 International Building Code (IBC) and ACI 318-14. The guide follows the long-established tradition of providing complete, tabulated designs of common reinforced concrete structural members. The tabulated designs are for normally encountered conditions and include axial and lateral loads.

Time Savings Design Aids (2 hours)
Presents practicing engineers with timesaving analysis, design, and detailing methods of primary framing members of a reinforced concrete building. Revised and updated to ACI 318-14, it incorporates seismic and wind load provisions to comply with the International Building Code (2015 IBC). All equations, design aids, graphs, and code requirements have been updated to the current codes. Expanded illustrations of the theory and fundamentals and new timesaving design aids were added to include a wider range of concrete strengths. Also contains a new chapter on sustainable design.

Attendees receive a free copy of the CRSI publication “Design Guide for Pile Caps”

DATE:
Monday, November 14 , 2016

PRESENTER:
Mike Mota, PhD, PE, F.ACI, F.ASCE, F.SEI

LOCATION:
Embassy Suites
1050 Westbrook Street (adjacent to Portland Jetport)
Portland, Maine

CREDITS:
4 PDH will be awarded, Diamond Approved
Note: NCSEA does not warrant that a course complies with the continuing education requirements in all jurisdictions

COST:
$85.00 for SEAM members, $135.00 for non-members

AGENDA:
7:30 am – 7:50am Light breakfast and Registration
7:55 am – 9:55 am Design of Pile Caps
10:05 am -12:05 pm Time Saving Design Aids

RSVP:
November 7, 2016

Seminar Material: 2008 CRSI Manual can be found by clicking here.

This entry was posted in SEAM Meeting Notice. Bookmark the permalink.

Comments are closed.