Category Archives: Learning Opportunity (non-SEAM)

Notice of non-SEAM Learning Opportunity. Note SEAM assumes no responsibility for content and/or continuing education credits for Learning Opportunities not presented or prepared by SEAM.

Semi-Rigid Diaphragms and Other Practical Structural Engineering Design Examples: Based on the 2006/2009 IBC and ASCE/SEI 7-05

April 4, 2011 – Portland, Maine Course Description: The 2006/2009 International Building Code (IBC) and ASCE/SEI 7-05 contain a variety of requirements that are difficult for structural engineers to apply during routine practice. To make matters worse, finding practical example … Continue reading

Posted in Learning Opportunity (non-SEAM) | Comments Off on Semi-Rigid Diaphragms and Other Practical Structural Engineering Design Examples: Based on the 2006/2009 IBC and ASCE/SEI 7-05

From SEAMass: Wind Design Using the New Provisions of IBC 2009

SEAMass is hosting a seminar on the the wind provisions from IBC 2009.  This event will be held on February 8, 2011 in Dedham, MA.

Posted in Learning Opportunity (non-SEAM), NCSEA | Leave a comment

FEMA 154 Training Information

The Maine Emergency Management Agency (MEMA) is sponsoring a training session for “FEMA 154, Rapid Visual Screening of Buildings for Potential Seismic Hazards and ROVER – Rapid Observation of Vulnerability and Estimation of Risk”. ┬áThis training is to be held … Continue reading

Posted in Learning Opportunity (non-SEAM) | Leave a comment

SEAM October Wood Design Seminar

2008 SDPWS (Special Design Provisions for Wind and Seismic Loading) and Overview of 2009 IBC Chapter 23 Plus Connection Design Seminar and Engineered Wood Products Seminar October 5, 2010 Presented by The American Wood Council (AWC) as part of the … Continue reading

Posted in Learning Opportunity (non-SEAM), SEAM Seminar Notice | Leave a comment